Print this page

Blanket (Batt and Roll) Insulation

Written by  The U.S. Department of Energy's Office of EERE

Blanket insulation — the most common and widely available type of insulation — comes in the form of batts or rolls. It consists of flexible fibers, most commonly fiberglass. You also can find batts and rolls made from mineral (rock and slag) wool, plastic fibers, and natural fibers, such as cotton and sheep's wool.

Blanket (Batt and Roll) Insulation

Topic Summary

Batts and rolls are available in widths suited to standard spacing of wall studs, and attic or floor joists. Continuous rolls can be hand-cut and trimmed to fit. They are available with or without facings. Manufacturers often attach a facing (such as kraft paper, foil-kraft paper, or vinyl) to act as a vapor barrier and/or air barrier. Batts with a special flame-resistant facing are available in various widths for basement walls where the insulation will be left exposed. A facing also helps facilitate fastening during installation. However, it's recommended that you use unfaced batts if you're reinsulating over existing insulation.

Standard fiberglass blankets and batts have a thermal resistance or R-values between R-2.9 and R-3.8 per inch of thickness. High-performance (medium-density and high-density) fiberglass blankets and batts have R-values between R-3.7 and R-4.3 per inch of thickness. See the table below for an overview of these characteristics.

Table 1. Fiberglass Batt Insulation Characteristics*
Thickness (inches)
R-Value
Cost (cents/sq. ft.)
3 1/2 11 12-16
3 5/8 13 15-20
3 1/2 (high density) 15 34-40
6 to 6 1/4 19 27-34
5 1/4 (high density) 21 33-39
8 to 8 1/2 25 37-45
8 (high density) 30 45-49
9 1/2 (standard) 30 39-43
12 38 55-60

*This table is for comparison only. Determine actual thickness, R-value, and cost from manufacturer and/or local building supplier.

Installation

The maximum thermal performance or R-value of blanket and batt insulation depends heavily on proper installation. Therefore, it's best to have a certified insulation installer do it. If you'd like to have it done professionally, you should do the following:

  • Obtain written cost estimates from several contractors for the R-value you need. Don't be surprised to find quoted prices for a given R-value installation to vary by more than a factor of two.
  • Ask contractors about their air-sealing services and costs as well, if needed. To evaluate batt installation, you can measure batt thickness and check for gaps between batts.

If you want to install the insulation yourself, carefully follow instructions and the necessary safety precautions. The insulation's manufacturer may offer instructions. You should also check your local building and fire codes. Please see the Installation and Reading List resources on the EERE website.

Cost

Blanket (batt or roll) insulation and installation usually costs less than other types of insulation.


Article source: The U.S. Department of Energy’s Office of Energy Efficiency and Renewable Energy (EERE). For the most up-to-date information please visit the EERE website.

Images | Diagrams

tab_contribute_image

Videos

tab_contribute_video

Whitepapers

tab_contribute_whitepaper

Last modified on Tue, Aug 07, 2012
blog comments powered by Disqus