Moisture Control in Walls

Written by  The U.S. Department of Energy's Office of EERE

It is a myth that installing vapor barriers is the most important step for controlling moisture in walls. Vapor barriers only retard moisture due to diffusion, while most moisture enters walls either through fluid capillary action or as water vapor through air leaks.

Moisture Control in Walls

 

 

 

 

Topic Summary

All climates require these moisture control steps:

  • Illustration of vapor barrier placement by geographical location. A shaded map of the southeastern United States is shown, with a label reading: In most cold climates, vapor barriers should be placed on the interior (warm-in-winter) side of walls. However, the map shows that in some southern climates, the vapor barrier should be omitted, while in hot and humid climates, such as along the Gulf coast and in Florida, the vapor barrier should be placed on the exterior of the wall. If you have a visual impairment and can't read this map, contact the webmaster or a local professional to help you determine where to place your vapor barrier. Below the map are Perm Ratings of Different Materials (Rating of 1 or less qualifies as a vapor barrier). The ratings listed are as follows: Asphalt-coated paper backing on insulation is 0.40, polyethylene plastic (6 mil) is 0.06, plywood with exterior glue is 0.70, plastic-coated insulated foam sheathing is 0.4 to 1.2, aluminum foil (.35 mil) is 0.05, vapor barrier paint or primer is 0.45, drywall (unpainted) is 50, and drywall (painted – latex paint) is 2 to 3.
    Install a polyethylene ground cover on the earth floor of houses with crawl spaces and slope the ground away from the foundations of all houses.
  • Install a continuous vapor barrier, if your climate needs one (see map on this page) that has a perm rating of less than one.
  • Place a termite shield, sill gaskets, or other vapor-impermeable membrane on the top of the foundation wall. This action will prevent moisture from wicking into the framed wall from the concrete foundation wall by capillary action.

Preventing Rain Penetration

Causes of rain leaks through exterior walls include improper installation of the following:

  • Siding materials
  • Poor-quality flashing
  • Weatherstripping or caulking around joints in the building exterior (such as windows, doors, and bottom plates).

Wind-driven rain can also penetrate the exterior finish.

To enhance protection against rain penetration, create a drainage plane within the wall system of the home.

Article source: The U.S. Department of Energy’s Office of Energy Efficiency and Renewable Energy (EERE). For the most up-to-date information please visit the EERE website.

 

Images | Diagrams

tab_contribute_image

Videos

tab_contribute_video

Whitepapers

tab_contribute_whitepaper

Published in 07 25 00 Weather Barriers
Last modified on Mon, Oct 18, 2010
More in this category: «Slab-on-Grade Foundation Moisture and Air Leakage Control »Combination Air Barriers/Vapor Diffusion Retarders
blog comments powered by Disqus
back to top

At Home Topics

AEC Pros Topics

Knowledgebase

About Us